Paracord Wallet | A Cool and Easy Paracord Project
Materials and Tools Needed:
- Paracord (can be 2 colors at 14 feet each)
- Lighter
- Pair of Scissors
- Super Glue
- A piece of cardboard or chipboard
- A crisp dollar bill
- Straight edge
- Straightening Iron
Step-by-Step Instructions:
Step 1: Cut the Paracord into Two Pieces
Cut 2 14-foot pieces of paracord. Snip any fused ends of the paracord, then gut them by pulling the inner cord out of the length of both 14-foot pieces.
Step 2: Flatten the Paracord with a Straightening Iron
Burn the ends of the paracords to prevent further fraying. Set the hair straightener to the lowest setting. Slowly pull the paracord through the straightening iron to flatten it. It may require more than one pass through the iron.
Step 3: Cut the Chipboard
Cut the chipboard by using a $20 bill to measure the approximate size of what its contents will be. Cut the chipboard to 2.5″ x 6.5″. These dimensions make for a very snug fit.
Note: The measurement can vary a bit depending on your preference.
Step 4: Wrap the Chipboard
Begin wrapping your base color around the long side of the chipboard. Start at one of the corners and work your way to the other end. The tighter you wrap, the firmer your end product becomes.
Step 5: Tape Down the Paracord Ends
Once the chipboard is fully-wrapped, tape down the ends of the paracord. It doesn't have to be super secure because you will have to move the tape several times. This is just to keep the paracord in place.
Step 6: Perform a Standard Over-Under Weave
Slide the gutted paracord over the blunt end of a skewer and glue it in place. Pick a corner to start and begin a standard over-under weave. Weave until you reach the other end and continue the weave around to the other side. This will be the outside of the wallet.
Step 7: Make the Pockets
Find the exact center of the backside by counting the total number of wraps, then divide by two. So if there are a total 34 wraps, the midpoint will be the 17th wrap. Weave up to the midpoint, then turn back the other way, and weave the second line across the front. Repeat the same steps for the beginning of the pocket on the opposite side until you run out of paracord or wraps to weave through.
Step 8: Tape Down the Loose Ends and Remove the Cardboard Form
Once you've completed the weave, tape down all the loose ends and start removing the cardboard form. Use scissors to cut it in half and pliers to pull it out. Trim the excess paracord in the corner, burn the ends, tuck them under the weave, and use super glue to secure them in place.
Step 9: Put Cash and Cards in the Wallet
Your DIY Paracord wallet should be good to go. Add cards in the pockets and cash in the middle. You can also use bobby pins to secure the cash.
Watch how the paracord wallet is made in this video by MOD
Making a wallet out of a paracord is just brilliant. The wallet is one of those everyday carry items you just can't leave behind. Now it's made into an easy DIY project that requires only a paracord, some tools, and a set of instructions to follow. Have fun making your Paracord wallet!
Got more creative uses for Paracord to share with us? Tell us about them in the comments section below!
Up Next: Your First Bug Out Bag – 50 Essentials For Your Kit
Editor’s Note: This post was originally published in December 2015 and has been updated for quality and relevancy.
Loved it. Thought it was a cool idea.